Сообщение
good_luck »
Читал мануал.
Сказано что нужно его удалить массив и заново добавить.
Он доступен в сети.
Все работает.
To recover from an unresponsive storage array:
1
Check the Tree View in the EMW to see if all storage arrays are unresponsive.
2
If any storage arrays are unrespon
sive, check the storage management
station network connection to ensure that it can reach the network.
3
Ensure that the RAID controller modu
les are installed and that there is
power to the storage array.
4
If there a problem with the storage array, correct the problem.
5
Perform one of these actions, depending on how your storage array is managed:
• Out-of-band managed storage array—Go to step 6.
• In-band managed storage array—Go to step 12.
6
For an out-of-band managed storage array, ensure that the RAID controller
modules are network accessible by using the ping command to ensure that
the RAID controller module can be re
ached. Type one of these commands,
and press Enter.
• ping
• ping
7
If the verification is successful
, see step 8, if not, see step 9.
8
Remove the storage array with the Un
responsive status from the EMW,
and select Add Storage Array to add the storage array aga
